Our rear disc brake kit is designed to fit all popular rear ends for street use. Maximum stopping power is achieved while retaining low rotational unsprung weight. Kit comes complete with hats, rotors, calipers, pads, and brackets.
Add $60.00 for polished caliper. Call about Brake Kit.

High quality Wilwood Engineeriing front brake kits look as good as they function! Available in both single piston for lighter vehicles and dual piston for heavier vehicles. Work great on TP as well as Early Ford spindles.

Polished kits include polished calipers and chrome mounting brackets.

TP and Ford hub kits allow the use of either Ford 5 X 4 1/2" as well as Chevy 5 X 4 3/4" bolt patterns. Chevy hub kits have specific bolt patterns and require ordering of specific part numbers.

*Single piston kits are one piston per caliper side (total of 2 pistons) while dual piston is 2 piston per side (total of 4 pistons).

360 degree caliper mounting brackets available for Total Performance and Ford spindles. Brackets available for single and dual piston calipers.

For use with Wilwood Bolt-On brake systems shown above.

Fender mounting provisions currently not available

These brackets are designed to work with bolt-on hub kits. Accepts Wildwood single or dual piston calipers.
For TP and Chevrolet spindles. Be sure to order for your correct spindle style.

These brackets are designed to work with bolt-on hub kits. Accepts Wildwood single or dual calipers.
For 1937-41 Ford Spindle Brake Brackets. Be sure to order for your correct spindles.

Available in both plain black powdercoated and polished aluminum finishes. Polished calipers are machined to have the look of billet aluminum. Single and dual piston styles available.

Available for both Wilwood single and dual piston brake calipers as used in our bolt-on brake kits.

NOTE: Brake pads are sold in pairs which means inner and outer pad for ONE caliper. Make sure to order TWO pairs when upgrading an entire brake system.

This disc brake kit is for 3000-lb. + vehicles using 1937 - 1948 Ford spindle. The kit features 11" x 1" rotors, caliper brackets, bearings, seals, adapters, GM calipers, pads, caps, hardware, and instructions. Choice of 4-1/2" and 4-3/4" bolt patterns.

Adapts 1970 - 1977 intermediate GM calipers and rotors to 1937 - 1948 Ford or TP spindles. Lower steering arms must be modified to work with this kit. Kit includes caliper brackets, bearings and installation instructions.

For 8" and 9" Ford rear. Includes backing plates, all new drums, shoes, wheel cylinders, and all necessary springs, adjusters, clips, and installation hardware. No provision for emergency brakes. (Use part no. BP169 or BP170.)
Measurements are required for this brake kit. Ask your salesperson.